Single Step Process! Does Not Require an Adhesive!
Create Amazing 3D Special Effects With Ease!
A single step puff transfer that does not require an adhesive backing! 878SS can be used with 900, 950 Series Hot Split Inks, 960 Hot Peel or 600SS Process Colors. 878SS Puff Transfers have the softest possible hand feel.
878SS can be used in the areas of a transfer print where an opaque white puff is desired. 878SS should be printed as the last colour down on a hot split transfer.
Paper: Soft Trans, Trans 55, Ultrastrip 3000, Tullis Russel or Transal.
Stencil: All types
Mesh: 60 to 110/inch (24T to 44T/cm).
Reducer: Reducers are not recommended with this product. **Please note that inks should be thoroughly stirred prior to printing, inks are thixotropic and will naturally reduce with stirring.
Squeegee: Use a medium (70) durometer.
Curing: 878SS must be gelled on the paper. If puffing occurs on the paper the transfer will not work properly as poor washability will occur. The inks will gel in a range between 220-240F (104-116C) for 60-90 seconds. Gel times are approximate only and will vary with the dryer used. To determine proper time for your particular dryer, preform the “finger test”. After gelling through the dryer, tap the design with your finger. This should leave a slight mark without lifting any ink with your finger.
Clean up: TR-Blend or 2000 Green
Transfer Application: Transfer your image at 375-400F (191-204C) for 4-10 seconds with medium pressure. Peel hot.
- Starting at $28.90
- Starting at $33.00
- Starting at $171.75
- Starting at $35.25
- Starting at $45.35
- Starting at $113.40
- Starting at $22.15
- Starting at $97.50
- Starting at $30.25
Transfer Printing Products, Resolution Dependant Image Printing InksStarting at $22.05
- Starting at $15.60